Beko Vacuum Cleaner bks 2123 User Manual

BKS 2123  
Vacuum Cleaner  
User Manual  
 
CONTENT  
1 Important Safeguards  
2 Technical Aspects Of Your Machine  
3 How To Use  
2
3
4-9  
4 How To Clean  
10-11  
1
 
1 Important Safeguards  
Basic safety Precautions should  
always be followed when using  
electrical appliances including the  
following :  
1. If the voltage written under the  
label of your vacuum cleaner is  
appropriate with the mains voltage  
in your house; you can use your  
vacuum cleaner. Otherwise motor  
may burn.  
2. Do not leave your vacuuzm  
cleaner plugged. Unplug it when  
you do not use or when service is  
necessary.  
3. Do not use your vacuum  
cleaner on wet surfaces and  
outside the house.  
4. This appliance is not intended  
for use by persons (including chil-  
dren) with reduced physical, sen-  
sory or mental capabilities, or lack  
of experience and knowledge,  
unless they have been given su-  
pervision or instruction concerning  
use of the appliance by a person  
responsible for their safety.  
Children should be supervised to  
ensure that they do not play with  
the appliance.  
5. If the power cord or plug is  
damaged, any drop or fall oc-  
cured, left outside, get wet or your  
device is not working; consult to  
authorized services.  
7. Do not unplug it by pulling from  
its cord. Unplug it by holding from  
the plug.  
8. Do not touch the plug or the  
device with wet hands.  
9. Do not drop any objects in to  
any open parts of your device.  
Make sure that the air passage  
holes and channels are open.  
10. Keep your hands and hair  
away from the working parts of  
the machine.  
11. Do not use your vacuum  
cleaner to clean flammable ob-  
jects such as cigarettes, matches,  
hot ashes.  
12. Do not use your vacuum  
cleaner without a paper filter or  
other filters are attached.  
13. Turn on all of the control  
buttons on your vacuum cleaner  
before unpluging.  
14. Do not vacuum burnable or  
flammable liquids. Do not use  
your device where these kinds of  
liquids exist.  
15. Unplug it when attaching or  
changing the accessories deliv-  
ered with your vacuum cleaner.  
16. Do not operate your vacuum  
cleaner while keeping it vertical.  
17. Small pieces of dust may  
cause clog of dust bag. This will  
terminate the air passage from  
the dust bag. In this case the dust  
bag must be changed altough the  
dust bag is not completely filled.  
6. Do not carry your device by  
pulling from its cable. Protect  
the cable from sharp edges, hot  
surfaces and be careful to not to  
closely pressed between a door  
and a door frame.  
2
 
2 Technical Aspects Of Your Machine  
17  
18  
19  
22  
20 21  
12345  
10  
6
7
8
9
16  
26  
15  
23  
14  
13  
11  
12  
25  
24  
27  
1- Plug and the power cord  
2- Brush parking area  
3- Cable twisting button  
4- On-Off button with power  
variator  
24- Dust brush  
25- Brush park projection  
26- Brush control pin  
27- Parquet carpet brush  
5- Carrying handle  
6- Blue indicator light  
7- Vacuum control button  
8- Dust indicator  
9- Front cover  
10- Hose inlet  
Max. Power : 2300 W  
Net weight : 6.6 kg  
Voltage and frequency : 220-  
240V AC 50 Hz  
Dust volume : 4 lt  
11- Exhaust filter area  
12- Wheel  
13- Body protection rubber  
14- Front cover opening pin  
Usage radius : 9 m  
Filtration layer : 7 levels  
15- 360 degrees turnable hose  
adaptor  
16- Elastic hose  
17- Handle  
18- Air control slide  
19- Telescobic extention pipe  
20- Upholstery brush  
21- Crevice tool  
22- Accessories carrying piece  
23- Telescobic control pin  
3
 
3 How To Use  
Pull the plug and the cable located  
at the back, outside; plug it. Stop  
pulling when you see the yellow  
sign on the cable, red sign comes  
after yellow sign, never pull when  
you see the red sign. Otherwise  
you may give harm to the cable  
twister of your product.  
Push the on-off button with power  
variator in order to operate your  
vacuum cleaner. When the on-off  
button with power variator is  
pushed, the blue indicator light  
around the vacuum control button  
will be on.  
You can control the vacuum  
power of your product with the  
vacuum power control button  
located on the body of your device  
while operating.  
Note: If your carpet brush sticks  
to your carpet because of the high  
vacuum power of your product,  
you may decrase the vacuum  
power by this button.  
Push the cable twister button on  
the device in order to twist the  
cable after the operation of the  
vacuum cleaner is finished. Do not  
step on the cable twister button.  
The mechanism may receive  
harm in case of stepping onto it  
strongly.  
4
 
You may reduce the vacuum  
power a little bit without using the  
vacuum power control on your  
product, by pulling the slide back  
when you want, using the air  
control slide on the handle.  
Dust indicator  
If you preferred to use a cloth filter,  
empty the cloth bag and wash in  
warm water when the dust indica-  
tor shows red. You may use soap  
when you wash the cloth bag.  
The cloth bag should be inserted  
into its place after it is dried for 24  
hours. While you are inserting the  
cloth bag into its place make sure  
that no space is left on the back-  
side and fully closed, otherwise  
dusts may escape into your motor  
and cause harm.  
Do not clean by rubbing the edge  
of the handle to carpets and coac-  
hes, otherwise the edge will melt  
and can not be used anymore.  
Use the brushes and accessories  
delivered with your product for  
cleaning.  
Dust indicator  
It shows the fullness proportion  
of your dust bag. If the indicator  
shows the red position more  
than %50, then it means that the  
changing time of the dust bag has  
arrived. The dust bag must be  
changed altough dust is not col-  
lected fully in the dust bag, if slight  
pieces of dust is filled the pores  
of the dust bag. If the indicator  
shows fully red, change the bag  
immedeately, otherwise the motor  
protector termostate will operate  
to terminate your product and  
your product will not work for 30  
minutes. In this case change the  
dust bag, wait your product to get  
cold and then operate.  
5
 
Push the bails on the hose adap-  
tor and pull it backwards in order  
to take the hose adaptor out of the  
vacuum cleaner.  
You can carry your product by  
holding from its handle. If you want  
to carry it vertically hold it from the  
cavity area for carrying located  
below the product.  
Picture 1  
Picture 2  
The hose adaptor of your product  
has a property of turning 360  
degrees. By this property it pro-  
vides an ergonomic usage during  
cleaning.  
You can attach the hose adaptor  
by pushing the hose adaptor in the  
direction of the arrow without pus-  
hing the nails as shown in picture  
1. Make sure that the nails on the  
hose adaptor are fitted into their  
places as shown in picture 2.  
6
 
The sides and the wheels of your  
product is covered with protec-  
tive rubber against crashes. By  
this way, straching your product  
and harming your furnitures are  
prevented.  
Crevice tool  
It can be used in  
crevice places such  
as interiors of  
furnitures and  
coaches.  
Upholstery brush  
It can be used  
to clean floor  
coverings, steps,  
inside of your  
car, coaches,  
furniture, etc.  
How to use the extention pipe  
The extention pipe of your product  
has telescobic property. In order  
to extent the pipe, push the pin  
shown in the picture and pull it  
from the edge by your hand. You  
may arrange its lenght as you  
wish.  
Dust brush  
Dust brush is  
used for taking  
the dusts of  
fragile objects  
and curtains.  
Pin  
How to use the accessories  
There is an accessories carrying  
adaptor on the extention pipe. You  
can use 2 of the accessorieses  
you wish by attaching on it. If you  
don’t want to use this adaptor,  
you can take its screw with a  
screw driver and take the piece  
out of the telescobic extention  
pipe.  
7
 
How to use the parquet, carpet  
brush  
Do not unplug it immedeately in  
order to stop the operation of  
your product, first push the on-off  
button with power variator to stop  
the operation of the product.  
There is a control mechanism on  
the left side of the parquet carpet  
brush. By the help of this control  
mechanism the brush is brought  
into the desired conditions suitable  
for the surface to be cleaned.  
You can park  
your vacuum  
cleaner in two  
different ways:  
a. In order to clean the rugs and  
the carpets, use your brush in  
normal condition. (Hair brushes  
are hidden.)  
vertical and  
b. In order to clean hard floor  
coverings such as parquet, vinyl  
floor covering, linoleum and flat  
surfaces such as walls without  
scrating, change the position of  
the control mechanism and clean  
on the hair brushes.  
horizantal. You  
can attach the  
brushes  
parking place  
in to the  
parking socket at the back of the  
product in order to park vertically.  
Warning: The carpet brush may  
stick to your carpet closely since  
the vacuum power of your vacuum  
cleaner is very high. For this rea-  
son it may cause exhausting arm  
and back aches. In order not to  
face such a problem, reduce the  
vacuum power of the product.  
Turning off and parking  
The operation of the vacuum cle-  
aner is stopped by pushing on the  
on-off button with power variator  
located on the body.  
8
 
Also you can attach the parking  
place at the back of your brush  
into the parking socket located at  
the back of your product and park  
horizontally.  
Warning: The dust bags purc-  
hased from unauthorised places  
other than services and dealers  
are not original. The dust bags  
which are not original are at very  
low quality. For this reason they  
are torn in a short time and your  
product becomes useless. For the  
breakdowns stemmed from using  
fake dust bags are considered out  
of warranty.  
Cloth dust bag  
If you use cloth dust bags instead  
of paper, you may empty it and  
reuse for many times. If the dust  
bag in your device is cloth then  
take the bag out as explained in  
“changing the paper filter”.  
Change your dust bag when the  
dust indicator glows red or if the  
vacuum power of your vacuum  
cleaner is not at the desired level.  
In order to change the dust bag,  
first open the front cover by lifting  
the pin located in the front. After  
opening, take it out by sliding it  
up over the cradle where full dust  
bag is located. The cover will not  
be closed before a new dust bag  
is inserted. Please do not force to  
close the cover otherwise plastic  
sections may harm.  
Cloth filter clips  
9
 
4
How To Clean  
You can clean cloth dust bags as  
fallows:  
• Hold the dust bag over a dust  
bin upside down. Take the clips off  
by pushing to the side.  
• Wash the cloth bag in warm wa-  
ter by hand. After washing, leave  
it to dry and never use before it is  
completely dried.  
• Close the bag by pushing the  
clips on the lower edge of the bag.  
If you are using a cloth bag we  
recommend you to change the  
motor filter once a year.  
How to clean the motor filter  
When the motor protection filter is  
extremely dusted, take it out and  
clean.  
Also take the motor protection  
filter out and shake every time  
when the dust bag is changed.  
Buy a new motor protection filter  
from the service and change once  
in every 5 paper filter change.  
Otherwise filter looses its effection  
since it finishes its usage life. On  
the other hand it may cause the  
motor to work louder and live  
shorter. Motor protection filter  
does not have a property such as  
being washed, it looses its effects  
when washed and causes the  
motor to be harmed.  
Motor protection  
filter  
Filter casette  
10  
 
Taking off the exhaust cover and  
exhaust filters  
Hepa filter  
On every fifth change of dust bag,  
with the change of motor protec-  
tion filter; open the exhaust cover  
at the back where the air gets out  
of your product, by pushing on  
the pin as shown in the picture in  
order to take the hepa filter and  
sponge filter located inside.  
Sponge filter  
Wash the hepa filter and the spon-  
ge filter in warm water and leave  
them to dry for 24 hours.  
Attention! Do not use devices such  
as hair dryers or stoves which give  
hot air out in order to dry.  
Do not insert the hepa filter and  
sponge into their places befo-  
re they are completely dried,  
otherwise humidity odour may be  
delivered, water splash may occur  
at the backside and filters may be  
harmed.  
11  
 

2Wire Gas Grill 1 TB LTU license T2526AA SNM User Manual
Acer Projector PW730 User Manual
Altec Lansing Speaker System FX2020 User Manual
Amana Clothes Dryer NGD7300W User Manual
American DJ Work Light Nitro User Manual
Atlona TV Cables AT WHD200 User Manual
Avocent Switch DSR1021 User Manual
Axis Communications Home Security System Q6045 E User Manual
Aztech Systems Router 305E User Manual
Baldor Portable Generator BALDOR GENERATOR User Manual